PENGARUH JEJARI HIDROLIK REGENERATOR DAN FREKUENSI GELOMBANG BUNYI TERHADAP KINERJA POMPA KALOR TERMOAKUSTIK GELOMBANG BERJALAN

Article Sidebar

PDF
Published: Jul 31, 2018
DOI: https://doi.org/10.24853/jurtek.10.2.147-152
Keywords:
thermoacoutic heat pump traveling-wave regenerator frequency

Main Article Content

Prastowo Murti
Mechanical engineering Department Faculty of Engineering Tidar University
Ikhsan Setiawan
Department of Physics, Faculty of Math and Science, Universitas Gadjah Mada
Muhammad Fadly
Department of Physics, Faculty of Math and Science, Universitas Gadjah Mada
Solli Dwi Murtyas
Mechanical engineering Department Faculty of Engineering Tidar University

Abstract

The refrigerant in the conventional heat pump has affected to the environmental. One of them is ozone depletion, thus, heat pump which has no impact on the environment is needed. The thermoacoustic heat pump is heat pump device which employs thermoacoustic phenomena and works with no refrigerant hence environmental benign. Thermoacoustics is phenomena sound wave that can cause a temperature difference or vice versa. The thermoacoustic heat pump produces temperature difference in the both side of the regenerator in which can be used as refrigerator and heater. Thermoacoustic heat pump consists of resonator tube, loudspeaker, and regenerator. Regenerator is the heart of thermoacoustic which is energy conversion takes place. Therefore, this research focuses on optimization of hydraulic radius of stainless steel wire mesh regenerator and frequency of the sound wave on the performance traveling-wave thermoacoustic heat pump. The experimental results show that hydraulic radius of regenerator and frequency of sound wave gives significant effect to temperature difference on the both side of the regenerator. The largest temperature difference reach is 51,5 °C, which is cold side have 12,2 °C that can be used as a refrigerator and hot side have 63,6 °C that can be used as a heater.

Downloads

Download data is not yet available.

Article Details

How to Cite
Murti, P., Setiawan, I., Fadly, M., & Murtyas, S. D. (2018). PENGARUH JEJARI HIDROLIK REGENERATOR DAN FREKUENSI GELOMBANG BUNYI TERHADAP KINERJA POMPA KALOR TERMOAKUSTIK GELOMBANG BERJALAN. Jurnal Teknologi, 10(2), 147–152. https://doi.org/10.24853/jurtek.10.2.147-152
Issue
Vol. 10 No. 2 (2018): Jurnal Teknologi
Section
Articles

COPYRIGHT POLICY

The author(s) of an article published in the Jurnal Teknologi retains ownership of the intellectual property rights in work (s).

PUBLISHING RIGHTS

The author(s) of an article published in the Jurnal Teknologi have unrestricted publication rights. The authors give the Jurnal Teknologi the right to publish the article and designate the Faculty of Engineering Universitas Muhammadiyah Jakarta Publishing as the original publisher of the article.

LICENSING POLICY
Journal of Mechanical Engineering and Sciences is an open-access journal that follows the Creative Commons Non-Commercial 4.0 International License (CC BY-NC 4.0), which states that: 


Under this license, the reusers must give appropriate credit, provide a link to the license, and indicate if changes were made. Users may do so in any reasonable manner, but not in any way that suggests the licensor endorses users or their use.
Please take the time to read the whole license agreement (https://creativecommons.org/licenses/by-nc/4.0/). As long as reusers follow the license conditions, the owner cannot withdraw these freedoms. The following components are included under this license:

Attribution: Users must provide appropriate attribution, including a link to the license, and indicate whether or not they made any modifications. Users are free to do so reasonably, but not in a manner that indicates the licensee approves of their usage.

NonCommercial: Users may not use the material for commercial purposes.

References

Anonim, Montreal Protocol http://en.wikipedia.org/wiki/Montreal_Protocol, diakses 20 Agustus 2017.

Bassem, M. Et al. 2011. Thermoacoustic Stirling Heat Pump Working as a Heater. Int. J. Refig. 34, 1125.

Kikuchi, R. Et al. 2015. Measurement of Performance of Thermoacoustic Heat Pump in -3 to 160 °C temperature range. Jpn. J. of Appl. Phys. 54, 117101.

Murti, P. Et al. 2015. Pengaruh panjang stack kasa kawat stainless-steel dan heat exchanger pada kinerja pendingin termoakustik gelombang berdiri berbiaya murah. Proceeding Seminar Nasional Teknik Mesin 10 (SNTM 10) 13 august 2015 Universitas Kristen Petra ISBN: 978-979-25-4419-0

Setiawan, I., et al. 2005. Rancang Bangun Piranti Termoakustik Sebagai Pendingin dan Pemanas Secara Simultan, Laporan Penelitian Antar Bidang Ilmu, Proyek Penelitian Antar Bidang Ilmu, FMIPA UGM, Yogyakarta.

Setiawan, I. 2014. Pembuatan Piranti Pendingin Termoakustik Gelombang Berjalan, Prosiding Seminar Nasional Fisika dan Terapannya (SNAFT IV), 15 November 2014, Universitas Airlangga, Surabaya, Indonesia.

Setiawan, I. Et al. 2017. Experimental Demonstration of the Dependence of Temperature Decrease on the Hydraulic Radius of Regenerator in a Traveling-Wave Thermoacoustic Refrigerator. J. Of Phys: Conf. Ser. 820 012012.

Swift, G.W, 1997, Thermoacoustic Engine, Editor M. J.Crocker, Encyclopedia of Acoustic, John Willey & Sons, New York.

Swift, G.W. 2001. Thermoacoustic: A Unifying Perspective For Some Engine And Refrigerator, Los Alamos National Laboratory, Acoustical Society of America Publication.

Tijani. MEH, et al. 2002. Construction and performance of a thermoacoustic refrigerator. Cryogenics, 42 (2002) 59–66.

Yazaki T. et al. 1998, Travelling wave thermoacoustic engine in a looped tube, Physics Review Letters, 81(15): 3128–3131.