PENGARUH BUTIRAN FILLER KAYU SENGON TERHADAP KARAKTERISTIK PAPAN PARTIKEL YANG BERPENGUAT SERAT TANDAN KOSONG KELAPA SAWIT

Sunardi Sunardi; Moh. Fawaid; Rina Lusiana

PENGARUH BUTIRAN FILLER KAYU SENGON TERHADAP KARAKTERISTIK PAPAN PARTIKEL YANG BERPENGUAT SERAT TANDAN KOSONG KELAPA SAWIT

Sunardi Sunardi, Moh. Fawaid, Rina Lusiana

Abstract

The waste of palm empty fruit bunches in Province Banten, especially Pandeglang and Lebak Region had been used optimally until today. The others hand, this waste to be environmental problem. This article will discuss the exploiting fiber of palm empty fruit bunches for reinforce the particle board. Composition and percentage of particle board consist of 15% fiber, 15% epoxy resin, 20% PVAc and 50% wood sawdust. Specimens were made by cold press single punch method with pressure 30 bar. The particle board characteristics will observed is density, hardness, impact strength, elastic limit, deformation and micro structure. From this research was obtained that the particle board mesh 18 have the highest elastic limit and impact strength, that is 1157.86N/mm² and 8.601kJ/m², respectively. The deformation and density is 2.42% and 0.87gr/cm³, respectively.

Keywords

filler mesh; palm empty fruit bunches; mechanical properties; particle board

Full Text:

PDF

References

(1) Sunardi, Moh. Fawaid dan M. Chumaidi, Pemanfaatan Serat Tandan Kosong Kelapa Sawit sebagai Penguat Papan Partikel dengan Variasi Fraksi Volume Serat, Jurnal Machine (2016), hal 36-39.

(2) Rina Lusiani, Sunardi, Yogie Ardiansah, Pemanfaatan Serat Tandan Kosong Kosong Kelapa Sawit sebagai Papan Komposit dengan Variasi Pajang Serat, Jurnal Flywheel (2015), hal 46-54.

(3) Sunardi, Moh. Fawaid, Fikry Rasyid Noor M, Variasi Campuran Fly Ash Batubara untuk Material Komposit, Jurnal Flywheel (2015), hal 90-102.

(4) Terciu, O. M.; Curtu, I. & Teodorescu Draghicescu, H., Effect of Wood Particle Size on Tensile Strength in Case of Polymeric Composites, 8th International Daaam Baltic Conference "Industrial Engineering (19-21 April 2012).

(5) S. C. Nwanonenyi, M.U. Obidiegwu, G.C. Onuegbu, Effects of Particle Sizes, Filler Contents and Compatibilization on the Properties of Linear Low Density Polyethylene Filled Periwinkle Shell Powder, The International Journal of Engineering and Science (2013), hal 1-8.

(6) Badan Standarisasi Nasional, Papan Partikel (2006).